Vyhledávání

XBee Shield V1.1

XBee Shield V1.1
  • Výrobce: Seeed Studio
  • Kat. číslo výrobce: WLS114A0P
  • Hmotnost: 10g
  • Záruka (měsíců): 24
Kód produktu: SE40
Cena bez DPH: 204,00 Kč
Cena s DPH: 246,84 Kč
Dostupnost: Vyřazeno

XBee Shield V1.1

XBee Shield V1.1 has been replaced with a newer version - XBee Shield V2.0.

Description: The XBee Shield allows an Arduino board to communicate wirelessly using ZigBee. It is based on the XBee module from MaxStream. This wireless module can communicate up to 100 feet indoors or 300 feet outdoors (with line-of-sight). It can be used as a serial / USB replacement or you can switch it into a command mode and configure for variety of broadcast and mesh networking options. This Arduino shield breaks out each of the XBee's pins to a through-hole solder pad. It also provides female pin headers for usage of digital pins 2 to 7 and the analog inputs that are covered by the shield (digital pins 8 to 13 are not obstructed by the shield, so you can use the headers on the board itself).

 XBee Shield V1.1

XBee Shield V1.1

Seeed Studio's Xbee shield is derived from Arduino Xbee shield, with following features: 
  • Smaller form
  • SMT package for most of the components
  • Cost reduction
For more details on configuring the XBee module, see the product manual from MaxStream. 
 
Arduino Xbee Shield Page: >>Click

 
To use X-CTU with Seeeduino, please upload following sketch:
 
void setup()
{
  DDRB=0;
  DDRC=0;
  DDRD=0;
}
 
void loop()
 

Features:

  • 31 mm x 41 mm board outline
  • Communication with Arduino / Seeeduino 

                 Via pin11,12 software Serial (Status 1/3)

                 Via hardware Serial (Status 4)

  • Setting by X-CTU via USB (Status 2)
  • Breakout all pins

 XBee Shield V1.1 with Arduino Board

Dimensions: 41 x 31 mm

 

References:

© 2015 Všechna práva vyhrazena.

www.hwkitchen.com